Enable an Exporting Connector
After selecting the right connector for your external time-series database, you can enable the exporting engine and configure your connector. This guide walks through enabling the exporting engine itself, followed by two examples using the OpenTSDB and Graphite connectors.
When you enable the exporting engine and a connector, Netdata exports metrics starting from the Agent restart time, not the entire historical database.
Once you understand how to enable a connector, you can apply that knowledge to any other connector.
Enable the Exporting Engine
Edit exporting.conf
using edit-config
from your Netdata config directory:
[exporting:global]
enabled = yes
Save the file but keep it open—you will edit it again to enable specific connectors.
Examples
Enable the OpenTSDB Connector
Use the following configuration as a starting point. Copy and paste it into exporting.conf
:
[opentsdb:http:my_opentsdb_http_instance]
enabled = yes
destination = localhost:4242
Replace my_opentsdb_http_instance
with an instance name of your choice, and change the destination
setting to the IP address or hostname of your OpenTSDB database.
Restart your Agent to initiate exporting to your OpenTSDB database. The Netdata Agent continuously exports metrics collected from the moment it starts. You can expect to see data appear in your OpenTSDB database within seconds of restarting the Agent.
Any further configuration is optional, based on your needs and the configuration of your OpenTSDB database. See the OpenTSDB connector doc and exporting engine reference for details.
Enable the Graphite Connector
Use the following configuration as a starting point. Copy and paste it into exporting.conf
:
[graphite:netdata]
enabled = yes
destination = localhost:2003
Replace netdata
with an instance name of your choice, and change the destination
setting to the IP address or hostname of your Graphite database.
Restart your Agent to initiate exporting to your Graphite database. The Netdata Agent continuously exports metrics collected from the moment it starts. You can expect to see data appear in your Graphite database within seconds of restarting the Agent.
Any further configuration is optional, based on your needs and the configuration of your Graphite database. See the Graphite connector doc and exporting engine reference for details.
Do you have any feedback for this page? If so, you can open a new issue on our netdata/learn repository.